diff options
| -rw-r--r-- | README.rst | 25 | ||||
| -rw-r--r-- | TODO.rst | 2 |
2 files changed, 18 insertions, 9 deletions
@@ -103,12 +103,14 @@ to use the simulator. Installing ---------- -Use an SWD programmer to install ``bootloader.hex`` to the PineTime. This -file is an Intel HEX file containing both the bootloader and the Nordic -SoftDevice. Be careful to disconnect cleanly from the debug software -since just pulling out the SWD cable will mean the nRF52 will still -believe it is being debugged (and won't properly enter deep sleep -modes). +Use an SWD programmer to install ``bootloader.hex`` to the PineTime. +This file is an Intel HEX file containing both the bootloader and the Nordic +SoftDevice. Once the bootloader is installed the watch will boot, display the +Pine64 logo and wait for a OTA update. + +See the `PineTime SWD programming guide <https://wiki.pine64.org/index.php/Reprogramming_the_PineTime>`_ +for instructions on how to reprogram the PineTime using various different SWD +programmers. .. note:: @@ -116,7 +118,12 @@ modes). protection enabled. You must disable the flash protection before trying to program it. -To install using Android device: + Be careful to disconnect cleanly from the debug software since just pulling + out the SWD cable will mean the nRF52 will still believe it is being + debugged (which harms battery life because the device won't properly enter + deep sleep states). + +To install the main firmware using an Android device: * Copy ``micropython.zip`` to your Android device and download nRF Connect for Android if you do not already have it. @@ -125,7 +132,7 @@ To install using Android device: * Connect to PineDFU using nRFConnect, click the DFU button and send ``micropython.zip`` to the device. -To install using Linux and ota-dfu: +To install the main firmware from a GNU/Linux workstation: * Look up the MAC address for your watch (try: ``sudo hcitool lescan``\ ). * Use ota-dfu to upload ``micropython.zip`` to the device. For example: @@ -157,7 +164,7 @@ Or just use: which can run these commands automatically. As mentioned above there are many drivers and features still to be -developed, see the `TODO list <TODO.md>`_ for current status. +developed, see the :ref:`Roadmap` for current status. Screenshots ----------- @@ -1,3 +1,5 @@ +.. _Roadmap: + Roadmap ======= |