Update to nimble 1.3 master branch commit 82153e744833821e20e9a8b0d61c38b2b0dbcfe1

WARNING : heartbeat task is disabled!

1 files changed, 48 insertions, 0 deletions

diff --git a/src/libs/mynewt-nimble/apps/mesh_badge/README.md b/src/libs/mynewt-nimble/apps/mesh_badge/README.md
new file mode 100644
index 0000000..8d2b3fa
--- /dev/null
+++ b/src/libs/mynewt-nimble/apps/mesh_badge/README.md
@@ -0,0 +1,48 @@
+### Mesh Badge
+
+
+##### Overview
+********
+
+This sample app for the reel board showcases Bluetooth Mesh
+
+The app starts off as a regular Bluetooth GATT peripheral application.
+Install the the "nRF Connect" app on your phone (available both for
+Android and iOS) to access the service that the app exposes. The service
+can also be accessed with any Bluetooth LE GATT client from your PC,
+however these instructions focus on the necessary steps for phones.
+
+##### Steps to set up
+***************
+
+* On your phone, use the nRF Connect app to Scan for devices and look
+   for "reel board"
+* Connect to the device. You'll see a single service - select it
+* Request to write to the characteristic by pressing on the upward pointing
+   arrow symbol
+* Select "Text" to enter text instead of hex
+* Enter your name (or any other arbitrary text). Multiple words
+   separated by spaces are possible. The font used on the reel display
+   allows three rows of up to 12 characters
+   wide text. You can force line breaks with a comma.
+* Press "Send" - this will trigger pairing since this is a protected
+   characteristic. The passkey for the pairing will be shown on the board's
+   display. Enter the passkey in your phone.
+* Once pairing is complete the board will show the text you sent. If
+   you're not happy with it you can try writing something else.
+* When you're happy with the text, disconnect from the board (exit the app or
+   go back to the device scan page)
+* Once disconnected the board switches over to Bluetooth Mesh mode, and you
+   can't connect to it anymore over GATT.
+
+If you configure multiple boards like this they can communicate with
+each other over mesh: by pressing the user button on the board the first
+word (name) of the stored text will be sent to all other boards in
+the network and cause the other boards to display "<name> says hi!".
+
+To reset a board to its initial state (disable mesh, erase the stored
+text, and make it connectable over GATT):
+
+* Keep the user button pressed when powering on (or press the reset button
+   when powered)
+* Wait until "Reseting Device" is shown